Kwik-Clean flux and patina remover

Never...ever...
use WATER to wash off your stained glass project.
Just Spray on Kwik-Clean & Wipe Off!

ELIMINATES 'WHITE MOLD'
Caused by Flux and Patina being left behind.

Remember when: the project was so big that you had to drag it out into your backyard to wash it off with the hose?

Now: just spray on Kwik-Clean after soldering to clean off the flux. Or spray on Kwik-Clean after applying patina to neutralize and clean up the left-over patina. No water is required for cleaning the window.

Works on FOIL

& LEAD projects

Kwik-Clean is a liquid which wipes off with just a paper towel. No need to use water, unlike the gel types of neutralizers.

Foil:
The Kwik-Clean solution is a liquid, not a gel. So it goes under the foil (in the air pockets where patina can be hiding) and neutralizes the patina. This is the area where White Mold starts to form.

Lead:
The Kwik-Clean solution, when sprayed on the solder joint, easily rolls completely around the joint removing all the flux. After the patina is applied, Kwik-Clean goes into the little pockets left in the putty and neutralizes any patina hiding there.

Check out what they've said about us.
(product review)

Kwik-Clean

Easy Instructions:

eliminates white mold

spray on - wipe off

No need to mix or dilute. After you have completed soldering one or both sides of your project, spray on Kwik-Clean. Typically, with a paper towel clean project thoroughly.

You may use the same paper towel or a clean one to apply the patina. Mixing the Kwik-Clean with the Patina gives added cleaning of the flux and a finer tone on the patina.

After Patina is applied, clean again with Kwik-Clean.

Polish as you normally would.

On pieces where White Mold is already present: For problem climates where White Mold is rampant. Steel wool after the first Kwik-Clean and before the Patina assures a finer clean of flux from under the foil. Then apply your patina and clean again with Kwik-Clean.

Kwik-Clean Material Safety Data Sheet

Produced by Hoevel ManufacturingLos Angeles, CA USA

800-959-9264310-823-8310